Costing Engineer

Job Scope: 1.Review Supplier quotation and cost analysis before proposing to management. 2.Performed yearly cost down with negotiation with suppliers. 3.Propose Maker layout during evaluation based on QCDD judgement. 4.Performed Audit (QAV1) at supplier premises. 5.Issued ePR. 6.Prepare cost analysis and VAVE for the new model development and mass production part. 7.Prepared Agreement for new supplier: a. Confidential Agreement b. Anti-Corruption Agreement c. Purchase Agreement d. Quality Agreement e. Supplemental Agreement 8.Issued Honda Drawing to supplier for request quotation and proposed maker layout. 9.Purchasing Strategy Creation 10.Supplier Management including maker part and supplier strategy for BSH model. 11.Request for the quotation for new model and mass production model and do the cost analysis before doing the proposal to management. 12.Maker Layout proposal including mold maker for plastic injection based on QCDD and propose to management 13.Update quarterly revise cost based on exchange rate fluctuation and material trend. 14.New Model Development Support and control target cost 15.To prepare the value analysis and value engineering for part improvement 16.Collaborate with duty section for the ILP application and excise duty exemption 17.Propose maker layout for new model based on drawing and purchasing policy under consideration on target cost. 18.Propose CR ideas such as localization activity, 3C, rebate, and VAVE for NM/MP model. 19.Cost analysis for New Model Parts. 20.Negotiate with suppliers in-order to fix reasonable part costs. 21.To provide data on section issues about the action plan and progress status by daily, weekly, and monthly. 22.To propose the material rate for management approval 23.To propose the exchange rate for management approval 24.Project involvement – NHC & I-Act 25.Create part strategy and synchronize with global direction. 26.Propose countermeasure for material CR with collaboration ASH. 27.To source new suppliers for localization activities 29.Perform quality audit visit (QAV1) for potential new supplier. 30.All documents must be prepared following ISO requirements. 31.Any other task that is assigned by a superior from time to time. Skills 1.Able to understand mechanical drawing 2D& 3D 2.Tooling fabrication for plastic & die casting 3.Hand on experience in: plastic injection process, die casting, metal stamping, MIG/TIGwelding, wire hardness